----- Original Message -----
From: "Jim Brown" <jim@audiosystemsgroup.com>
To: <amps@contesting.com>
Sent: Sunday, March 19, 2017 3:52 PM
Subject: Re: [Amps] 240 Volt Blowers needed
On Sun,3/19/2017 11:26 AM, Jim W7RY wrote:
Now looking for some 240 volt blowers suitable for 8877 (need 4 blowers)
and also something suitable for a pair of 3-500 tubes (need two blowers
for them. And they can be 120 vac).
Yes, remember that it's perfectly OK to run a 120V load between one side
of the TX primary and its center tap. This is often done by the first rate
amp mfrs. And remember that it is NOT OK (and is illegal) to run a 120V
load between one side of the line and ground. Indeed, putting load current
on ground is a recipe for hum pickup. And bonding neutral to ground is
even worse.
73, Jim K9YC
Except those high enders that went to ground
Carl
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|