TenTec
[Top] [All Lists]

Re: [SteppIR] RE: [TenTec] SteppIR Ten Tec Orion interface

To: <tentec@contesting.com>
Subject: Re: [SteppIR] RE: [TenTec] SteppIR Ten Tec Orion interface
From: "Jeff Griffin" <kb2m@comcast.net>
Reply-to: Jeff Griffin <kb2m@comcast.net>, tentec@contesting.com
Date: Mon, 24 May 2004 07:20:11 -0400
List-post: <mailto:tentec@contesting.com>
 Difference noted Carl, but polling has to be on for the SteppIR control box
to work in auto-tune mode....

73 Jeff kb2m

----- Original Message ----- 
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Monday, May 24, 2004 12:01 AM
Subject: Re: [SteppIR] RE: [TenTec] SteppIR Ten Tec Orion interface


> Jeff,
>
> In polling mode, my N4PY software only reads the frequency form the Orion
> every 2.5 seconds.  If you turn polling off, then when you tune from the
> pod, the program is driving the Orion and this delay goes to almost zero.
>
> Carl Moreschi N4PY
> Franklinton, NC

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>