Jeff,
How does the SteppIR get serial data while my program owns the serial port.
Maybe I could work something out here and make the best of both worlds.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Jeff Griffin" <kb2m@comcast.net>
To: <tentec@contesting.com>
Sent: Monday, May 24, 2004 11:20 AM
Subject: Re: [SteppIR] RE: [TenTec] SteppIR Ten Tec Orion interface
> Difference noted Carl, but polling has to be on for the SteppIR control
box
> to work in auto-tune mode....
>
> 73 Jeff kb2m
>
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Monday, May 24, 2004 12:01 AM
> Subject: Re: [SteppIR] RE: [TenTec] SteppIR Ten Tec Orion interface
>
>
> > Jeff,
> >
> > In polling mode, my N4PY software only reads the frequency form the
Orion
> > every 2.5 seconds. If you turn polling off, then when you tune from the
> > pod, the program is driving the Orion and this delay goes to almost
zero.
> >
> > Carl Moreschi N4PY
> > Franklinton, NC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|