To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] Elecraft K3 vs Orion? |
From: | Duane - N9DG <n9dg@yahoo.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Tue, 1 May 2007 11:43:13 -0700 (PDT) |
List-post: | <mailto:tentec@contesting.com> |
Oopsie on my part. I guess miss-understood Doug, KF6DX's status during the Orion's development. Excuse me while I go wipe this egg off my face... Duane N9DG --- "Ten-Tec Inc. Amateur Radio Sales" <sales@tentec.com> wrote: > > > As you may recall a > > significant part of the original Orion's design work was > more > > or less outsourced as well. > > Hello -- > > The above is not correct. > > All of the Orion and Orion II design was done entirely by > Ten-Tec > employees. No outside contractors for either hardware or > firmware were used. > > 73 > Scott Robbins > W4PA __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | Re: [TenTec] Elecraft K3 vs Orion?, Ten-Tec Inc. Amateur Radio Sales |
---|---|
Next by Date: | Re: [TenTec] Elecraft K3 vs Orion?, Neal Campbell K3NC |
Previous by Thread: | Re: [TenTec] Elecraft K3 vs Orion?, Ten-Tec Inc. Amateur Radio Sales |
Next by Thread: | Re: [TenTec] Elecraft K3 vs Orion?, Grant Youngman |
Indexes: | [Date] [Thread] [Top] [All Lists] |