TenTec
[Top] [All Lists]

Re: [TenTec] Original Orion Firmware

To: <tentec@contesting.com>
Subject: Re: [TenTec] Original Orion Firmware
From: "Geoff Stokes" <geoff.g0byh@btinternet.com>
Reply-to: geoff.g0byh@btinternet.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 17 Aug 2010 09:14:04 +0100
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
John,

I am using V 2.062a, the only complaint I have is that the noise reduction
(NR) is unusable.

I did not go to the Beta V 2.063Xg as there were so many negative comments
on the reflector some of which
related to the type of modes which I use on the ORION I.

I operate SSB, PSK & RTTY, the latter two which are controlled entirely via
Macro's & CAT (using MixW)on the PC, therefore a reliable stable serial
interface is required.

Thanks for all your effots.

Geoff Stokes - G0BYH



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>