There's a battery behind the front panel of the Orion. It may need to be
replaced. Follow the old instructions on the Tentec site for how to modify
the Orion for the Version 2 sweep to get to the battery.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Martin Sole" <hs0zed@csloxinfo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, October 16, 2010 2:10 AM
Subject: [TenTec] Orion resets at every power up
After being able to load software into the radio again, not sure if it was
PC serial port cable or connectors but it's okay now, I'm now seeing that
at
almost every power cycle the radio does a master reset. The sequence of
events is as follows:
Radio off
Power up and master reset complete appears
Radio boots but has unusable audio
Power down followed by power up again about 5 seconds later radio starts
normally
Power off and leave for a short while, sometimes only 20 seconds or so,
power up again causes master reset
Needless to say this is frustrating.
RAM clear and forced master reset do not appear to have helped.
Is it a 'known' issue?
Thanks
Martin, HS0ZED
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|