There's a battery behind the front panel of the Orion. It may need to be
replaced. Follow the old instructions on the Tentec site for how to modify
the Orion for the Version 2 sweep to get to the battery.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Martin Sole" <hs0zed@csloxinfo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, October 16, 2010 2:10 AM
Subject: [TenTec] Orion resets at every power up
> After being able to load software into the radio again, not sure if it was
> PC serial port cable or connectors but it's okay now, I'm now seeing that
> at
> almost every power cycle the radio does a master reset. The sequence of
> events is as follows:
>
>
>
> Radio off
>
> Power up and master reset complete appears
>
> Radio boots but has unusable audio
>
> Power down followed by power up again about 5 seconds later radio starts
> normally
>
> Power off and leave for a short while, sometimes only 20 seconds or so,
> power up again causes master reset
>
>
>
> Needless to say this is frustrating.
>
>
>
> RAM clear and forced master reset do not appear to have helped.
>
>
>
> Is it a 'known' issue?
>
>
>
> Thanks
>
> Martin, HS0ZED
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|