Late last year the serial port on my Orion failed. The DSP module was
returned to Ten-Tec who replaced the 4 ceramic 1uF capacitors. I replaced
the board and it worked well. Until today. I have been setting up different
audio feeds from the radio and swapping firmware to see the different output
levels. Trying to re-load 2.059 today the update program would not
communicate with the radio and left it in flash update mode. Power cycling,
master resets, RAM clear resets all result in it sitting with a SYSTEM
LOADING screen permanently. Only the flash update mode can be entered but
without any serial comms nothing happens. I have measured the DC volts on
each pin of the MAX232 with no PC connected and get the following:
1=6.7V
2=9.1V
3=2.2V
4=4.3V
5=-4.7V
6=-9.06V
7=9.1V
10=0V
11=3.3V
12=4.3V
13=0V
14=-9V
15=0V
16=4.6V
Any idea if these look about right?
Note that this was all working fine the last time I touched it a couple of
weeks ago. No changes to PC, serial port cables etc. It was all fully
functional.
Not really looking forward to returning the board again and the resulting
$100 plus $50 shipping etc etc. Hoping for some hand holding help, or at
least a pointer or two.
Thanks in advance.
Martin, HS0ZED
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|