[TowerTalk] Abrasion resistant wire antenna support suggestions

[NC3Z Gary <nc3z@outlook.com>]

I have been using what I thought was high quality UV resistant Dacron to 
support my inverted L's. But the problem is as it runs through the 
support pine trees it comes into contact with several limbs and branches 
and it has been abraded to the point of failure in about 6 months. This 
has happened a couple of times.

Any good products out there that is more resistant to limb abrasion?


Gary Mitchelson
NC3Z/4 Pamlico County, NC FM15

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk