I would also add that com ports 3-9 are listed in Device Manager as
Virtual Ports within the TI-8 Unit.
On 11/4/2016 21:04, Thom wrote:
I have a Kenwood TS-480sat. I also have a Rigexpert TI-8 Interface to
drive the radio in FSK,
I have the following ports on my TI-8:
Cat Com 3
PTT Com 7
FSK Com 9
I have MMTTY set up with this and it works fine
Writelog is a no go. I am using XMMT.oxc and it points to MMTTY.
Writelog is setup with EXTFSK 1.06 and is set to com 9
any ideas?
--
73
Thom KI8W
"Living deep in the black hole of RF"
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|