| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Ten Tec 238A settings? |
| From: | Ed <w3nr@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 13 Apr 2008 16:15:08 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
Denton wrote: Ahhhhhhh...success! Ran 600ohm feeders all the way to the tuner in the shack! Since there is no wiring in that part of the ceiling, I just screwed some cuphooks on the ceiling and suspended the feeders in them. Preliminary tuning is nice and smooth. I did that once.....after $23,000 worth of fire damage from a direct lightning strike that followed the open wire feeder into the house. Be careful and take precautions. 73 Ed W3NR |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten Tec 238A settings?, Denton |
|---|---|
| Next by Date: | Re: [TenTec] Omni-6 rotary encoder, Thomas |
| Previous by Thread: | Re: [TenTec] Ten Tec 238A settings?, Denton |
| Next by Thread: | Re: [TenTec] Ten Tec 238A settings?, Denton |
| Indexes: | [Date] [Thread] [Top] [All Lists] |