TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec 238A settings?

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec 238A settings?
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Apr 2008 21:50:53 -0500
List-post: <mailto:tentec@contesting.com>
Didn't have an arrestor on the outside, eh. Folks that put up antennas need to understand the need for lightning protection systems. I've found that most don't........understand. Many take shortcuts and omit critical components and configurations. Lightning can be extremely nasty but it doesn't have to be such.

73
Bob, K4TAX


----- Original Message ----- From: "Ed" <w3nr@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 13, 2008 3:15 PM
Subject: Re: [TenTec] Ten Tec 238A settings?


Denton wrote:
Ahhhhhhh...success! Ran 600ohm feeders all the way to the tuner in the
shack! Since there is no wiring in that part of the ceiling, I just screwed some cuphooks on the ceiling and suspended the feeders in them. Preliminary
tuning is nice and smooth.

I did that once.....after $23,000 worth of fire damage from a direct
lightning strike that followed the open wire feeder into the house.

Be  careful and take precautions.    73

Ed W3NR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>