I assume the knife switych is protected against the weather otherwise.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Bob McGraw - K4TAX
Sent: Monday, April 14, 2008 10:56 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Ten Tec 238A settings?
Yes, but with a knife switch one can't operate and be protected at the same
time. With the spark plug arrestor operation continues with protection.
The knife switch is best when one is away from the station. That presumes
one does not forget to close it when securing the station. Also, the knife
switch should be located outside of the structure for added safety.
73
Bob, K4TAX
----- Original Message -----
From: "Lyle Dunlap" <qskqrq@grics.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, April 14, 2008 7:15 AM
Subject: Re: [TenTec] Ten Tec 238A settings?
> One can use all sorts of spark plugs & things to drain off those little
> sparkies mother nature puts out, however its hard to beat a DPDT heavy
> knife
> switch.
> For over 25 years I had a 3 wire Rhombic up 375 ft on a leg and with 4500
> feet of wire basically in the form of a capacitor you can have your own
> fireworks display. Go with a knife switch.
>
> Lyle W9FCX
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|