Towertalk
[Top] [All Lists]

Re: [TowerTalk] DX Engineering 66-Foot Vertical?

To: TowerTalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] DX Engineering 66-Foot Vertical?
From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
Date: Sat, 14 Mar 2009 03:53:52 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Oops...
<snip>
>  I can start with anything from 2 to 2 1/2 or 3". the sections 
> should have a 1'. What do I need?  If need be I can take standard 
>   
That should have said I should have close to a 1' overlap (+ 2 or 3" - 0)
> lengths, cut them and use the excess"  I was told they charge by the 
> foot whether I use a full length or they cut it to length when I needed 
> some a few years back, which was a surprise.
>
> "I think" which means I don't know for sure, that "standard lengths" are 
> 6', 8', 10' and 12'
>
> That is what I'd give to the Aluminum shop in Saginaw.  True I could 
> take any list of 6061 tubing and figure out what I need but the shop 
> could do it in 10% of the time and for very little charge.
>   
73

Roger (K8RI)
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>